18
1.Put the bound pipes in the wall pipe and
then make them pass through the wall hole.
Step nine: hang the indoor unit
2.Hang the indoor unit on the wall-mounting
frame.
3.Stuff the gap between pipes and wall hole
with sealing gum.
4.Fix the wall pipe.
5.Check if the indoor unit is installed firmly
and closed to the wall.
indoor
outdoor
wall pipe
sealing gum
upper hook
lower hook of
wall-mounting frame
Note:
● Do not bend the drain hose too excessively
in order to prevent blocking.
1.Select installation location according to the
house structure.
Step one: fix the support of outdoor
unit(select it according to the actual
installation situation)
2.Fix the support of outdoor unit on the
selected location with expansion screws.
Note:
●Take sufficient protective measures when
installing the outdoor unit.
●Make sure the support can withstand at least
four times the unit weight.
●The outdoor unit should be installed at least
3cm above the floor in order to install drain
joint.
●For the unit with cooling capacity of
2300W~5000W, 6 expansion screws are
needed; for the unit with cooling capacity
of 6000W~8000W, 8 expansion screws are
needed; for the unit with cooling capacity of
10000W~16000W, 10 expansion screws are
needed.
1.Connect the outdoor drain joint into the hole
on the chassis, as shown in the picture
below.
Step two: install drain joint(Only for
cooling and heating unit)
2.Connect the drain hose into the drain vent.
chassis
outdoor drain joint
Drain hose
drain vent
Installation of outdoor unit
at least 3cm above the floor
