- 4 -
English
Fr
ançais
Español
Neder
lands
Italiano
JK-DVF
ABC
3
MountinG
JK-DA
①
Removing the
main unit from the
mounting frame
Place " UP" upwards
Remove the main unit.
(Loosen the locking screws.)
Screwdriver
Tighten
Loosen
Main unit
Mounting
screws x 2
1-gang box
83.5 mm
(3-5/16")
Mounting frame
Drainage hole
Do not block the holes.
Front panel
Pry off the front panel with
a flathead screwdriver.
Flathead
screwdriver
Main unit
<Bottom surface>
③
Mount the main unit on
the mounting frame, and fit
the front panel on.
Removing the front panel
JK-DV
ABC
Special
screwdriver
Special
screwdriver
Loosen
Tighten
Tighten Mounting
screws x 4
Vandal-resistant front panel
Vandal-resistant front panel
Flush mount
back box
Transparent
nameplate
75 mm
3''
110 mm
4-3/8''
180 mm
7-3/32''
45 mm
1-25/32''
150 mm
5-15/16''
Drainage hole
Do not block the holes.
Ø 6 mm
Ø 1/4"
35 mm
1-3/8"
Anchor bolts x 4
To
insertion
opening
To
insertion
opening
To
insertion
opening
Using the transparent nameplates
Using the transparent nameplates
Inserting the transparent nameplates
Inserting the transparent nameplates
①
Remove the vandal-resistant front panel.
②
Peel off the protective seals on the plate (both sides).
③
Fill in the name of the resident on the transparent
nameplate.
Be sure to leave 25 mm (1") of white space on the left end
to account for insertion.
④
Insert the filled-in transparent nameplate at the specified
insertion opening (indicated with
in diagram).
①
Remove the vandal-resistant front panel from the flush mount back
box.
②
Peel off the protective seals on the plate (both sides).
③
Fill in the name of the resident on the transparent nameplate.
Be sure to leave 25 mm (1") of white space on the left end to
account for insertion.
④
Insert the filled-in transparent nameplate at the specified insertion
opening on the rear side of the vandal-resistant front panel (indicated
with
in diagram).
25 mm
1"
25 mm
1"
②