o
Unlike monitor mode, when a sub station is selected for two way communication, the status
shown in the
Sub Station Location List
will change from available to connected.
o
To terminate communication, click on the
Off Button
or select another station. You can also
terminate the call by pressing the Esc key on your keyboard.
10.5 Activating the dry contacts on the IPW-1A.
o
To activate the door release on the IPW-1A that you have selected, click on the
Door Release
Button
.
This will allow you to activate the “Form C” dry contact on the IPW-1A associated with
the sub station. Note: If the IPW-1A is not configured for Door Release, an error pop-up will
occur.
10.6 All Call / Group Paging
– Limited to 1 PC at a time on the network.
10.6.1 All Call
– Calls to stations that are on the Sub Station Location List.
o
To make an all call announcement to all sub stations in your list, click on the
All Call Button
and
make your announcement after the pre-tone. Stations that are in communication with another
CommuniCenter user will hear the announcement and when the announcement is over, will
resume normal communication. During the announcement the
Sub Station Location List
will
show that the sub stations are in use. Units on the ignore list will not receive all call
announcements.
10.6.2 Group Paging
o
To make a group paging announcement to preselected groups, open the
Paging Group List
.
You can open the
Paging Group List
by clicking on the
Groups Button
. Group calling to an
ignored station is possible if you set the sub as part of a group before you ignore it.
Pg. 16