AIMIX MD-16E, Reference Manual, Page: 37 / 64

- 27 -
UG-MD16E-EN (V1.3-190708)
MD-16E
Mixer Reference manual
2.4.3. Add effect
[Step 1]: Click the bus button on the panel that
needs to add effects
,
Then select the [FX/USB/AES] group in the navigation bar or click the fader
page button switch to the FX channel, cancel the route mute, adjust the FX routing volume,
and assign the effect signal to the output bus.
[Step 2]: Set up the routing for FX1 or FX2 according to the steps in Section 2.3. Then exit the routing
settings state, click the fader page button switch to the FX channel, click the FX channel name bar or
click the button Go to the FX settings screen and select the FX type as described in the next section.
01
Navigation bar, click the corresponding index page,
you can quickly switch to the page where the
channel is located. The channel corresponding to
the brown dot is a valid routing channel.
02
System parameter button, Click to enter the
system parameter control page.Same function as
the button
on the panel.
03 Scene button , click to enter the scene control page. 04 Mute switch. The FX channel route is muted
when red is lit and no signal is coupled to the bus.
05 Routing channel gain. Unit: dB. Change by fader
adjustment.
06 Fader gain scale, unit: dB.
07 Route Gain Fader (the fader slider is brown).
Channels that are not brown cannot be set as routes.
08
Signal level meter
，
unit
：
dBfs
。
make -20dBfs as
standard level U.
09 Each bus can be independently selected for its
access point corresponding to the input channel.
The FX has no access point selection function.
10 Channel name bar.
Click the channel name bar to enter FX
setting interface.
11 Channels overview area.
The channel of the brown
fader slider is a valid routing source channel, which can be
used as a routing input to adjust routing parameters.
12 Current channel master control panel, adjustable
gain and mute, etc.
03 02 01
04
05
06
08
07
09
10
11 12