20
21
MXS 1.2 STRADA
CHAPTER 5
After setting the protocol the system comes back to “ECU Stream” page and shows two check-
box, both disabled:
n
“Enable the CAN Bus 120 Ohm Resistor”: the CAN Bus needs two 120 Ohm resistors at its
two extremes. In case your MXS 1.2 Strada is the only device connected to the ECU the 120
Ohm resistor should be enabled, else, very easily, it is already present in the existing network
and should be disabled;
n
“silent on CAN Bus”: usually the ECU aspects an acknowledge signal when transmits a mes-
sage and, as default, the MXS 1.2 Strada transmits this signal. Sometimes, particularly when
there are other devices in the network, MXS 1.2 Strada should not transmit it; in this case, if
you enable this flag, MXS 1.2 Strada remains completely silent.
This page works exactly like ECU Stream one. Here you can find additional CAN modules. To
load your additional module CAN protocol:
n
enter “CAN2 Stream” tab
n
press “Change protocol” button
n
select “Manufacturer” and “Model” (in the example (MEGALINE/PADDLESHIFT)
n
press OK
5.2.3 CAN2 Stream configuration
MXS 1.2 STRADA OK.qxp_Layout 1 02/10/18 15:08 Pagina 21
