7 |
BOIL-DRY PROTECTION
CLEANING AND MAINTENANCE
Should you accidentally let the Kettle operate without water, the boil-dry
protection will automatically switch off the power. If this occurs, allow the
kettle to cool for 10 minutes before filling with cold water to try and re-boil.
Always disconnect the Kettle from the electrical power supply and allow it to
cool down completely before cleaning.
1.
Never immerse the Kettle, Power Cable or Base in water, or
allow moisture to contact with these parts.
2.
Wipe the outside of the Kettle with a damp cloth or cleaner,
never use a poisonous cleaner.
3.
Remember to clean the filter at 3-month intervals. For easier cleaning,
detach the filter and then replace it after cleaning.
CAUTION:
Do not use chemical, steel, wooden or abrasive cleaners
to clean the outside of the kettle.
4.
When not in use or storage, the power cable can be stored at the
bottom of the Base.
5.
Lift the Kettle from the Base and then pour the water.
Note:
Operate carefully when pouring the water from your kettle as
boiling water may result in scalding, don’t open the lid while the
water in the kettle is hot.
6.
The Kettle will not re-boil until the on / off Switch is pressed down
again. The Kettle may be stored on the Base when not in use.
Note:
Always disconnect the power supply when not in use.
