Usage and Maintenance Instructions
Ver. 2 07/2012 (2193)
3
3.
Adjust the rear supports so that they are the same width as the furniture.
4.
Carefully tilt the furniture forwards and slide each of the rear supports under the
rear corners of the chair.
5.
Lower the chair onto the supports and ensure that the castor is sitting inside the
well.
6.
Move to the front of the chair and carefully tilt it backwards, swing the front corner
supports round and lower the furniture onto them, again ensure the castor is
located in the well.
7.
Go to each corner and rotate the support to make sure that it is snug against the
furniture.
8.
Once each corner is positioned with the minimum intrusion and is tight to the
furniture tighten the wing nut.
9.
Before first use check the furniture is stable on the raiser.
FITTING TO BEDS – ONE LPMPR UNIT PER END + CENTRAL SUPPORT & ADDITIONAL
HEIGHT SECTIONS TO ACHIEVE RAISE HEIGHT
1.
Firstly set all supports to the height of raise you require, it is important that all
corners are of equal height.
2.
Place one pair of raisers parallel at the foot of the bed.
3.
Loosen wing nuts and adjust to same width as the bed. For double beds use
spreader bars to extend the width
4.
Lift bed and place corners on to the supports, ensure the castor is sitting inside the
well.
5.
Push corner supports tight up against the bed, rotate each support to give best
possible fit. If using a central support ensure it is pushed up tight to sides of bed.
6.
Repeat for the opposite end of the bed.
7.
Tighten all wing nuts and check bed is stable on raisers before use.
FITTING TO SETTEES – ONE LPMPR UNIT EACH END + CENTRAL SUPPORT &
ADDITIONAL HEIGHT SECTIONS TO RAISE HEIGHT
(Small and Two Seat Settees)
1.
Place the raiser unit on the floor behind the settee.
2.
Attach an extended spreader bar to each raiser unit. (If extra height sections are to
be used they should be clipped onto the supports, it is important that all corners
are of equal height).
3.
Loosen the wing nuts, and position the front corner supports as far out as possible.
4.
Adjust the rear supports so that they are the same width as the furniture.
5.
Carefully tilt the furniture forwards and slide each of the rear supports under the
rear corners of the furniture.
