Usage and Maintenance Instructions
Ver. 2 07/2012 (2193)
2
INTRODUCTION
Thank you for deciding to purchase the Furniture Raisers from Aidapt. The Furniture Raisers
are manufactured from the finest materials available. When used correctly they are designed
to give many years of reliable, trouble-free service.
NB. This equipment must be installed by a competent person.
VG830
Furniture Raiser Component (Main Unit)
VG830B
Furniture Raiser Component (Clip on Sections)
VG830D
Furniture Raiser Component (Spreader Bar)
VG830KA
Bed Raiser Kit: Single Bed
VG830KB
Bed Raiser Kit: Double Bed
VG830KC
Armchair Raiser Kit:
Maximum User Weight: 500 kg (78 stone) including furniture.
Do not exceed the weight limit stated – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments as this
may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault, do not
use your product, but contact your supplier for support.
INTENDED USE
Our Multi-Purpose Furniture Raiser raises beds, chairs and settees. The Langham Products
Multi-Purpose Raiser is unique in its design and versatility.
Each support pivots on the link bars to ensure a snug fit to the side of the furniture either at
the corner or as a central support along the side of the bed supported.
The whole unit is height adjustable with simple to use clip on sections, each 20 mm (3/4"),
giving a wide range of heights.
•
As with all devices designed to assist the elderly or disabled, care should be taken
to avoid sudden or undue movement when using the equipment.
•
This product is designed for use in a static mode only.
•
Furniture may be heavy. Please take care when fitting the raiser.
FITTING TO ARM CHAIRS – 2 LPMPR UNITS + SPREADER BAR + ADDITIONAL HEIGHT
SECTIONS TO ACHIEVE RAISE HEIGHT
1.
Place the raiser unit on the floor behind the chair, attach the spreader bar running
across the chair arm to arm (If extra height sections are to be used they should be
clipped onto the supports, it is important that all corners are of equal height).
2.
Loosen the wing nuts, and position the front corner supports as far out as possible.
