17
3) Pulse output width setting
4) Pulse output setting conditions
Select the No.5 mode.
Pressing and holding the “FLOW RATE” switch for two seconds (i.e. start of setting) will
make the setting value for output pulse width blinking (0.5 seconds interval).
You can change the setting value for pulse output width between 40 and 120 in order by
pressing the “FLOW RATE” switch while the setting value is blinking (40 ms and 120
ms).After the setting has been completed, press and hold the “FLOW RATE” switch for
two seconds (i.e. completion of setting) to confirm the setting value, and then the display
will return to the item selection (current setting value display).
The following figure shows the overview of setting flow.
Pressing the switch will change
the setting value for pulse output
width between 40 and 120.
*1
Press the “FLOW
RATE” switch
Press and hold the “FLOW RATE”
switch for two seconds
(confirmation of setting)
5. Pulse output width setting (current setting value display)
Press and hold the “FLOW
RATE” switch for two
seconds (start of setting)
Setting value for pulse output width
*1 Depending on the model, the restrictions specified in 4) Pulse output setting conditions are
applied to the pulse output unit and the pulse output width.
Model
Pulse
output
unit
Pulse
output
width
Configuration
allowed/not
allowed
Configuration
allowed/not
allowed
Configuration
allowed/not
allowed
Model
Model
Pulse
output
unit
Pulse
output
unit
Pulse
output
width
Pulse
output
width
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
○
(
Allowed)
x
(Not
allowed)
x
(Not
allowed)
x
(Not
allowed)
x
(Not
allowed)
x
(Not
allowed)
x
(Not
allowed)
