SOLUTIONS
|
+49 2173 -164-0
| FREE FAX 0800 / 2 42 32 93 |
|
WWW.AHB-SHOP.COM
4
USER MANUAL
Operating Instructions Battery Booster 30.000mAH
General:
This booster is designed to support weak or empty vehicle battery during star-
tup. It is not intended to be used as a charging device.
It supports a weak or dead battery between 8 and 11V.
Charge the device before use:
- Connect the charger to the charging socket (DC-IN 15V).
- Plug the charger into a 220V socket.
- The booster turns on automatically; the display indicates the charge state, the charging
voltage and a flashing charging bar.
- The charger lights red during the charging progress, otherwise green.
- Another operation is not possible during charging.
Operation:
- Turn the booster ON by pressing the ON/OFF button.
- The device switches on; the display indicates the charging status.
- If the booster is not sufficiently charged, an error message is displayed.
(Insufficient capacity). Charge the device.
- To support a car battery, press the TEST button.
- A red LED lights up, the pliers are monitored for about 30 seconds.
- The device is in standby mode.
- Connect the RED PLIERS to the “+” terminal, and the BLACK PLIERS to the “–“
terminal (corresponds to the vehicle mass) of the battery.
- In case of faulty connection such as reverse polarity, undervoltage, or short circuit, a warning
signal sounds and an error message is displayed. (ERROR)
- Start the vehicle. If the battery voltage drops below 11V, i. e. the vehicle battery is low/empty,
the booster turns on automatically.
- The red LED changes to green.
- Do not start for more than 10 seconds, take breaks.
- After 30 seconds, the booster switches off the pliers, the LED goes out.
Warning: Avoid short circuits with green activation LED. The device may be da-
maged.
Attention: if the battery is deeply discharged (voltage below 8V), a warning
signal sounds, the booster does not switch on.
After the start:
- Switch off the pliers if they are not switched off automatically (LED test red). To do this, press
the Test button, the green LED changes to red. Disconnect the pliers. First minus, then plus.
- The booster turns off automatically after about 1 minute.
- If you press the ON/OFF button for more than 10 seconds, you can switch off the booster
manually.
Attention:
This booster is a jump starter and should only be used as this.
Depending on the model, there is a mechanical or electronic pliers’ contact. This contact pro-
tects the built-in Lithium-ion batteries.
In case of mechanical contact (can be recognized
by the red pliers‘ extension cable), please ensure the complete enclosure of the
pliers to the positive terminal of the battery.
