AgXcel Synergist GX40 System, Reference Manual, Page: 7 / 36

7
877.218.1981 info@agxcel.com
Revised09.2018R1
WWW.AGXCEL.COM 877-218-1981 info@agxcel.com
Quick Start Setup Instructions for Trimble’s FM
750, FM1000, FMX Rate Controller
• Select Field-IQ and press the Setup button.
• The next page will display 3 selections, press the “ Material Setup ”
button.
• Select one of the available material profiles or press Add to add a
new material. Press Edit to change any of the parameters of the
material selected.
• Material Type will need to be set to Liquid .
• Give the material a name that makes sense.
• Set
Target Rate 1 & Target Rate 2
as desired.
• Rate Increment increases or decreases your Target Rates by this
amount each time you press the rate Adjustment Switch on the Master Switch
Box.
• Manual Rate Increments work when the Rate Switch is in the Man-
ual Position . This number controls the speed at which the valve
increases or decreases when you press the
Rate Adjustment Switch
on the Master Switch Box .
• Minimum Rate is typically set at 0 .
• Maximum Rate is set at something higher than the maximum rate
that will be applied.
These parameters may be adjusted as desired.
• Jump Start Speed is the speed the system will ramp up to when the
operator pushes the Jump Start button on the Master Switch Box .
3.0 – 5.0 mph
is a good setting for this.
• Jump Start Timeout allows the Jump Start Speed to run for a spe-
cific amount of time.
• Apply Latency to Boundary:
set as needed so the system begins
applying when needed.
AgXcel recommends setting the Rate Snapping to On . This will smooth
out the rate fluctuation seen on the screen. If you are within the rate
smoothing range, the applied rate will just show your target rate and
not small deviations from target rate.
Configuration – Setup cont.
AGXCEL INTEGRATION INTO THE TRIMBLE
(Read Instructions Completely before Beginning Installation)