www.agxcel.com
6
Quick Start Setup Instructions for Trimble’s FM
750, FM1000, FMX Rate Controller
PO Box 1611
Kearney, NE 68848
877.218.1981
www.agxcel.com
PLEASE NOTE: Your setup may vary.
Not all screens are shown. See Trimble’s Opera-
tor’s Manual for safety information and additional setup/operating information.
Please
ensure you have the latest firmware installed!
MENU STRUCTURE FOR LIQUID RATE CONTROLLER
System Information
From the home screen, you can select 3 tabs; Support, Sys-
tem Information and Camera. The System Information tab is
shown above. This will show what Trimble components are
properly connected to your display. If your fertilizer system
quits functioning, first check that the Control Module is still
recognized on the display. If not, inspect the Trimble wiring
harness connections or consult your Trimble dealer.
CFX-750 and FM750 Users
Information in this manual is applicable to the 750 except for
screen shots shown in the Setup & Operation. The calibration
and setup values in this section DO apply to the 750. How
-
ever, the 750 has a completely different screen layout and
menu structure that is not shown in this manual. Use your
Trimble manual to navigate, then enter the appropriate num
-
bers from the AgXcel manual.
Configuration – Setup & Calibrate
In the Setup & Calibrate menus, you will set the Trimble Field-IQ to work
properly with the AgXcel Fertilizer System. Carefully follow these steps to
first make sure you have the proper settings. Then, run the tests shown to
verify your fertilizer system is ready to go to the field.
• From the home screen, choose
Setup & Diagnostics
.
•
The Configuration screen below will appear. Choose
Field-IQ
. The Setup & Cali
-
brate buttons will be locked, shown by a padlock next to them.
• Push
Setup
, then enter “
2009
”
•
After entering the code, the locks will disappear. Push
Setup
to proceed to the
next steps.
Home
•
Support
•
System Information
•
Camera
Configuration
• Setup
•
Calibrate
•
Diagnostics
Config Selection
•
Display
•
Vehicle
•
Implement
AGXCEL INTEGRATION INTO THE TRIMBLE
(Read Instructions Completely before Beginning Installation)
PLEASE NOTE:
Your setup may vary. Not all screens are shown.
See Trimble’s Operator’s Manual for safety information and ad-
ditional setup/operating information.
Please ensure you have the
latest firmware installed!
Summary of Contents for Synergist GX40 System
Page 36: ......