Wiring the Decagon 10HS or GS1 sensor
to the Aqua Trac Unit
Wiring the Decagon 10HS or GS1 sensor: You can have up to 4 Decagon 10HS/GS1
sensors wired into this unit. Starting with sensor 1, find the first group of terminals (3) as
shown above.
1.
Connect the White wire from the Decagon 10HS/GS1 sensor to the terminal marked
PWR as shown above.
2.
Connect the Bare wire from the Decagon 10HS/GS1 sensor to the terminal marked
GND as shown above.
3.
Connect the Red wire from the Decagon 10HS/GS1 sensor to the terminal marked
SIG as shown above.
Note: Repeat steps 1-3 for any additional Decagon 10HS/GS1 sensors (WM 2, 3, 4)
Please follow the jumper settings on page 14 - set to Decagon 10HS for both the 10HS and GS1
sensors. Page 4