7
Basic rules for more safety –
important safety instructions
Please read these operating and safety instructions carefully before
using your grain mill.
This will avoid errors and accidents and can secure the functional and
safe use of the appliance.
Please keep this user manual and should you hand the mill to any third party
ensure the next user has the manual.
When operating this grain mill the following precautionary and
safety measures must be applied:
1.
Read all Instruktion carefully.
2.
The appliance must only be used for its intended purpose
(household production of flour and bran)
3.
The mill must only be operated indoors and never outside.
4.
Before operating the appliance, it is essential to check its flawless condition.
Special attention must be paid to damaged cables, brittle or cracked
insulations or damaged housings. Should the mains cable or other parts of the
mill be damaged, repair work must be carried out by the manufacturer,
respectively authorized, qualified persons. Reparaturen dürfen nur durch von
Agrisan GmbH autorisierte Personen durchgeführt werden.
5.
Repairs may only be carried out by persons authorized by Agrisan GmbH.
6.
Defective or deficient electrical appliances must not be operated.
7.
The seller must immediately be informed of any defects.
8.
Only connect the mill to a correctly installed protective mains socket. Before
doing so, please check that the voltage specified on the nameplate on the
grain mill matches the voltage of the energy supply.
9.
Multiple plugs and extension cables must not be overloaded.
10.
The cable of the mill must not be allowed to hang over the edge of the table
or work surface. Any contact with hot plates or any other sources of heat
must be strictly avoided at all times.
11.
Leads to electrical appliances must not be laid or squashed over sharp edges
or moveable parts.
12.
Appliances must only be operated with the intended switches.
13.
Safety devices must not be modified or turned off.
14.
Should any disturbances occur immediately turn the appliance and disconnect
