21
Problem Solutions
Problem
Cause
Solution
Motor is blocked and
cannot be switched on
Mill was adjusted in still-
stand mode from „coarse
“to „fine “although whole
grain kernels were
between the mill stones.
Reset the mill to a
coarser setting and then
adjust slowly to a finer
setting
Grain was too damp
Dry grain
Grain was milled too
finely
Adjust the mill to a
coarser setting –
especially when milling
oily grain such as rye
Especially small grain
kernels e.g. Quinoa were
processed
Fill very small grain
kernels slowly by hand
into the hopper.
Mill stones are smeared
Grain is too damp or too
oily
Please dry damp grain
and/or use a coarser
setting
Oily grain very easily
causes smearing - use a
coarser setting
The mill has turned itself
off.
The mill was over-loaded.
Turn the motor off and
leave to cool for at
least one hour
Flour spout is blocked
Clear flour spout
Backlog of flour in the
container
Empty container
The mill has turned itself
off, after about 30
minutes
This is a normal way of
protecting the appliance!
Mill no longer processes
fine enough
Hopper is turning
independently towards a
coarser setting
Tighten locking screw
Locking screw worn at
front
Grind surface of
locking screw at the
front or renew.
