AgriMetal GR-400, Operator'S Manual

Page: 64 / 76

56
a
b
c
1. Review the Operator's Manual for the en-
gine.
2. Place all controls in neutral, stop engine,
turn off ignition and wait for all moving parts
to stop before changing oil and filter.
3. Allow the engine to cool before changing
the oil. Hot oil can cause burns if it contacts
exposed skin. It is best to change oil while
the engine is warm to keep the contami-
nants in suspension.
4. Place a pan under the drain plug.
5. Remove the drain and allow the oil to drain
for 10 minutes.
6. Install and tighten the drain plug.
7. Dispose of the used oil in an approved
container.
8. Remove hydraulic oil filter.
9. Apply a light coat of oil to the O ring and
install the replacement filter. Snug up by
hand and then tighten another 1/2 turn.
10. Fill the hydraulic oil reservoir with specified
oil.
11. Run the engine for 1 to 2 minutes and
check the hydraulic system for oil leaks.
12. If leaks are found around the drain plug or
filter, tighten slightly. Repeat step 11.
13. Check oil level in reservoir. Top up as re-
quired.
6.2.3 CHANGING HYDRAULIC OIL AND FILTER
Fig. 53 HYDRAULIC SYSTEM
Hydraulic System Oil Filter
a. Sight Glass b. Fill Cap c. Drain Plug