Agrimate AM-708T, User Manual

Page: 21 / 38

21
• After every 50 hours of operation, detach the spark plug and remove dirt from the electrodes
with a wire brush or similar.
• The correct electrode gap is 0.6 to 0.7mm.
• When replacing plugs, please use designated items.
!
IMPORTANT
• If too much fuel is absorbed or poor quality oil is used, the spark plug electrodes become dirty,
making the engine harder to start.
• Note that using any spark plug other than those designated may result in the engine failing to
operate properly or in the engine becoming overheated and damaged.
• To install the spark plug, first turn the plug until it is finger tight, then tighten it a quarter turn
more with a socket wrench.
TIGHTENING TORQUE: 14.7 to 21.6 N.m. (150 to 220 kgf-cm)
• Adjusting the engine
Although the engine is adjusted on leaving the factory, after repeated use it may sometimes
require readjustment or maintenance. Please consult your original supplier regarding
inspections and maintenance other than those shown below.
• Idling speed
If the engine stalls or the pump continues to move when in idling position with the throttle
lever completely lowered, readjust the engine speed using the idle speed adjuster on the left
of the carburetor.
a. idle speed adjuster
b. increase speed
c. reduce speed