10
1/4" x 3/4"
HEX BOLT
1/4"
NYLOCK
NUT
1/4"
WASHER
1/4"
WASHER
1/4" x 1"
HEX BOLT
2. Place the top angle support and cart bag ontop of the
cart as shown in fi gure 12. Then, using a screwdriver
or other sharp object, poke holes through the cart bag
for the bolts that will be assembled in step 3.
3. Attach the top angle support and braces to the cart using
fi ve 1/4" x 3/4" hex bolts, two 1/4" x 1" hex bolts through
the braces, fourteen 1/4" washers (one placed on each
side) and seven 1/4" nylock nuts.
DO NOT TIGHTEN
YET
. See fi gure 12.
NOTE: Cart bag not shown for clarity.
FIGURE 12
While performing the assembly operations
in step 3, make sure the cart bag is between
the top angle support and the cart.
#10-32 x 5/8"
TRUSS BOLT
ROPE
SECURE
ROPE
KNOT
#10-32
NYLOCK
NUT
CLIP
4. Slide each end of the rope through the holes in the
tailgate shown in fi gure 13.
5. Tie a knot in the end of each side of the rope to secure
the rope in place. Keep knot loose. See fi gure 16.
HINT:
Knot may need to be moved up or down in rope to
secure tailgate. See step 9 for more information.
6. Slide tailgate into tailgate guides.
7. Attach clips to bottom lower support rod and fasten
them to the tailgate using two #10 x 5/8" slotted head
bolts and #10 nuts. See fi gure 13.
8.
TIGHTEN
all bolts assembled in steps 1 through 7.
9. Secure tailgate rope around the bolts shown in fi gure
13. If rope does not keep tailgate held down or rope
is too short to secure around bolts, move the knot up
the end of the rope to loosen or down to tighten. Once
knot is in desired location, tighten the knot to secure it
in place.
NOTE: Cart bag not shown for clarity.
FIGURE 13
Summary of Contents for VAC-N-GO 45-0407-131
Page 2: ...2...
