8
3/8" x 1"
HEX BOLT
3/8" x 3"
HEX BOLT
3/8" NYLOCK NUT
FIGURE 6
12. Assemble the engine to the tongue using two 3/8" x 3"
hex bolts in the rear holes, two 3/8" x 1" hex bolts in the
front holes and four 3/8" nylock nuts. See fi gure 6.
HINT:
Use caution when assembling engine to tongue. Have
another person assist you if you are having diffi culty.
HINT:
For easier assembly, support the tongue with a block
of wood.
HOSE HANGER
ASSEMBLY
13. Place the hose hanger rod assembly down into the hose
hanger bracket on the impeller housing assembly. See
fi gure 7.
FIGURE 7
25" TARP
STRAP
HOSE HANGER
ASSEMBLY
16. Loop the 25" tarp strap under the hose. Fasten the hooks
to the hose hanger rod assembly. See fi gure 9.
FIGURE 9
CLAMP
HOSE
HOSE ADAPTER
(NOZZLE)
14. Place a hose clamp onto the end of the hose. Push the
hose onto the hose adapter (nozzle). Tighten the hose
clamp onto the hose and hose adapter.
Do not collapse
the hose adapter when tightening the clamp.
See
fi gure 8.
15. The remaining hose clamp will be used later to fasten
the hose to the deck adapter.
FIGURE 8
Summary of Contents for VAC-N-GO 45-0407-131
Page 2: ...2...
