6
sTeP 7:
(see fiGure 7)
•
Attach a wheel brace (10) to each upper and lower
kickstand tubes (2 and 3) using two 1/4-20 x 1-1/4
GR5 hex bolts (Y) and 1/4-20 Nylock hex nuts (T).
Y
9
T
3
2
Y
fiGure 7
sTeP 8:
(see fiGure 8)
•
Place .531 x 1 x .059 washers (W) on each end of the
axle (10) and then slide both ends of the axle (10) into
the holes of the wheel braces (9).
•
Secure in place using a 1/8 x 1-1/2 cotter pin (X). Use
pliers to bend the ends of the 1/8 x 1-1/2 cotter pin (X)
once inserted into the holes on the axle (10).
X
10
W
10
W
9
fiGure 8
sTeP 9:
(see fiGure 9)
•
Place a .531 x 1 x .059 washer (W) followed by a
wheel (V) and then another .531 x 1 x .059 washer
(W) onto the end each axle (10).
•
Secure each wheel by inserting a 1/8 x 1-1/2 cotter
pin (X) into the hole on the end of each axle (10). Use
pliers to bend the ends of the 1/8 x 1-1/2 cotter pins
(X) to secure them in place.
W
10
W
V
X
fiGure 9
sTeP 10:
(see fiGure 10)
•
Slide the handle tube (1) into the ends of each upper
kickstand tube (2). Secure the connections in place
using a 1/4 x 1-1/2 clevis pin (D) and 3/32 x 1.8 hair
pin (I) on each side.
D
D
1
I
I
2
fiGure 10
