8
STEP 4: (SEE FIGURE 4)
•
Place the R.H. Side Plate onto the bolts you inserted
into the tractor frame. Install three 3/8" flanged lock
nuts and one 5/16" nylock nut onto the bolts.
Tighten.
•
Repeat for the L.H. Side Plate.
HINT:
To help prevent the carriage bolts from spinning,
push against the head of the bolt while tightening to keep
the square neck of the bolt seated in the square hole.
3/8" FLANGED
LOCK NUT
5/16" NYLOCK
NUT
FIGURE 4
RIGHT SIDE VIEW
STEP 3: (SEE FIGURE 3)
•
Install a hex head shoulder bolt, a 3/8" washer and a
3/8" flanged lock nut in the R.H. and L.H. Side Plates.
FIGURE 3
RIGHT SIDE VIEW
3/8" WASHER
SHOULDER
BOLT
3/8" FLANGED
NUT
R.H. SIDE PLATE
LH. SIDE PLATE
STEP 6: (SEE FIGURE 6)
HINT:
Do not completely tighten the plastic ties until so
instructed in step 7.
• Position the wire harness' black relay box against the
front of the battery tray on the right hand side. Attach
it to the slot in the top of the battery tray using a
plastic tie.
• Route the end of the wire harness with the green and
black wires around behind the tractor's wiring and
then forward along the right side of the tractor.
• Loosely attach the wire harness to rear of the right
hand side plate installed in step 4, and to the right
front corner of the tractor frame using two plastic ties.
• Route the other end of the wire harness with the
brown and black wires around behind the battery
cable on the left side of the battery and then along the
left side of the tractor.
• Loosely attach the wire harness to the hole at the
bottom left corner of the lower dash using a plastic tie.
• Loosely attach the wire harness to the rear of the left
hand side plate installed in step 4, and to the left front
corner of the tractor frame, using two plastic ties.
STEP 5: (SEE FIGURE 5)
• Remove the two screws in the right side of the plastic
dash housing.
• Install the cable clip onto the rocker switch wiring.
Attach the switch mounting assembly and clip to the
side of the plastic dash housing, using the two screws.
FIGURE 5
RIGHT SIDE VIEW
SWITCH
ASSEMBLY
ATTACH RELAY
BOX TO SLOT
ATTACH WIRE
HARNESS HERE
CABLE CLIP
ORIGINAL
SCREWS
CONNECTING THE RELAY BOX
STEP 6: (SEE FIGURE 5)
FRONT MOUNTED BATTERY ONLY
• Position the wire harness relay box against the front of
the battery tray on the right hand side. Attach it to the
slot in the top of the battery tray using a plastic tie.
• Connect the long black wire on the wire harness to
the negative post on the battery.
• Connect the red wire (with circuit breaker) to the
positive post on the battery.
