9
INSTALL HANGER BRACKETS AND SHOULDER
BOLTS TO OUTSIDE OF FRAME
STEP 9: (SEE FIGURE 7)
•
Remove the bolt, if present, in the hole directly behind
the brake rod on the left side of the tractor frame.
• Attach the L.H. Hanger Bracket (tube facing out) to the
hole using a 5/16" x 3/4" self threading bolt.
• Install a round head shoulder bolt into the hole that is
9-1/2" to the rear of the bolt you just installed. Secure
it with a 3/8" flange nut on the inside of the frame.
FIGURE 7
LEFT SIDE VIEW
5/16" x 3/4" SELF
THREADING BOLT
L.H. HANGER
BRACKET
BRAKE ROD
3/8" FLANGED
NUT
SHOULDER
BOLT
5/16" x 3/4" SELF
THREADING BOLT
R.H. HANGER
BRACKET
RIGHT END OF
BRAKE ROD
3/8" FLANGED
NUT
SHOULDER
BOLT
STEP 10: (SEE FIGURE 8)
•
Remove the bracket, if present, from the hole directly
behind the end of the brake rod on the right side of
the tractor frame. Store the bracket and bolt.
• Attach the R.H. Hanger Bracket to the hole using a
5/16" x 3/4" self threading bolt.
• Install a round head shoulder bolt into the hole that is
9-1/2" to the rear of the bolt you just installed. Secure
it with a 3/8" flange nut on the inside of the frame.
FIGURE 8
RIGHT SIDE VIEW
BLACK WIRE
BROWN WIRE
NUT
NUT
WASHER
WASHER
WASHER
WASHER
FIGURE 6
RIGHT SIDE VIEW
INSTALLING THE WIRE HARNESS
STEP 8:
• Connect the three wires of the switch mounting
assembly to the wires with mating connectors from
the wire harness, joining together like colored wires.
• Route the end of the wire harness with the green and
black wires around behind the tractor's wiring and
then forward along the right side of the tractor.
• Route the other end of the wire harness around to the
left side of the tractor.
• Loosely attach the wire harness to rear of each side
plate installed in step 4, and to the front corners of the
tractor frame using two plastic ties per side.
• Connect the wire harness to the winch motor using
the pre-assembled nut and washers. Place the brown
wire on the top terminal and the black wire on the
bottom terminal. See figure 6.
• Tighten the plastic ties.
STEP 7:
REAR MOUNTED BATTERY ONLY
• Mount the wire harness relay box in front of the
solenoid on the right hand side of the gas tank,
attaching it with a plastic tie.
• Attach the long black wire of the wire harness under
the head of the screw that fastens down the right
hand side of the gas tank.
• Attach the red wire (with circuit breaker) to the rear
solenoid terminal where the battery cable is attached.
• Connect the short red, black and green wires to the
three wires of the switch mounting assembly, joining
together like colored wires.
