4
asseMBLY INsTruCTIONs
FIGure 2
TOOLs reQuIred FOr asseMBLY
(1) Hammer
(2) 7/16" Wrenches
(1) Pliers
Lay out and identify parts and hardware using the
illustrations on pages 2 and 3.
FIGure 1
sTeP 1:
(see FIGure 1)
•
Insert the plugs (X) into the ends of the hopper
support tubes (8) and (9).
•
Attach the left (8) and right (9) hopper support tubes
to the stand tube using two 1/4" x 1-3/4" hex bolts (C)
and 1/4" nylock nuts (K).
do no tighten completely.
C
K
C
K
X
X
9
8
K
K
B
B
V
4
FIGure 3
T
T
3
H
FIGure 4
hole on this end
sTeP 2:
(see FIGure 2)
•
Insert the bushing (V) into the cross brace (4).
•
Attach the cross brace to the hopper support tubes
using two 1/4" x 2-1/2" hex bolts (B) and 1/4" nylock
nuts (K).
do not tighten completely.
sTeP 3:
(see FIGure 3)
IMPOrTaNT:
Be sure the gearbox is turned so that the
hole in the axle is located on the side shown.
•
Install the gearbox assembly by inserting the end of
the vertical spreader shaft into the cross brace bushing
and inserting the axle into the ends of the hopper
support tubes.
sTeP 4:
(see FIGure 4)
•
Slide the flat sided bearings (T) onto the axle and
insert them into the ends of the hopper support tubes.
•
Slide the spreader impeller (3) onto the vertical shaft
and secure it with a 1/8" x 1-1/2" cotter pin (H).
