Agri-Fab 45-0460, Operator'S Manual

Page: 5 / 24

5
FIGURE 5
FIGURE 6
5/16" x 1"
HEX BOLT
NYLON
WASHER
5/16"
NYLOCK NUT
MOTOR
ASSEMBLY
5/16" FLAT
WASHER
SCREEN
1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
CLIPS
CLIP
SCREEN
SHAFT
SEAL
BUSHING
Place screen down into hopper. 9.
DO NOT
place it under
the clips in bottom of hopper at this time. See figure 6.
Place motor assembly down into hopper, inserting end of 10.
spreader shaft into impeller coupler. Secure it with a 1/8"
x 1-1/4" cotter pin, spreading ends of pin around coupler.
See figure 5.
Fasten motor mount bracket to hopper using four 5/16" x 11.
1" hex bolts, 5/16" flat washers, nylon washers and 5/16"
nylock nuts. See figure 5.
Lift screen up and slide seal down spreader shaft to rest 12.
against plastic bushing in bottom of hopper. See figure 6.
Slide one edge of the screen under one of the clips. 13.
Then, slightly bow the screen to slide the opposite
side of the screen under the other clip. See figure 6.
FIGURE 7
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
Attach the control mount tube to the top of the 14.
spreader using a 5/16 x 1" hex bolt and 5/16" nylock
nut. See figure 7.
NOTE:
The end of the control mount tube with the smaller
bend should be attached to the spreader.
FIGURE 8
5/16" x 1"
HEX BOLT
5/16" NYLOCK NUT
Attach the flow control to the control mount bracket 15.
using a 5/16" x 1" hex bolt and a 5/16" nylock nut.
See figure 8.