6
5/16" x 1-1/2"
CARRIAGE BOLT (C)
5/16" NYLOCK NUT (J)
R.H. HITCH TUBE
5. Tip the sweeper housing back to the upright position
.
6. Cut off the plastic tie that holds the height adjustment
tube in place.
7.
(Figure 5)
Assemble the R.H. hitch tube to the sweeper
housing using two 5/16" x 1-1/2" carriage bolts (C), and
two 5/16" nylock nuts (J).
Do not tighten yet.
Repeat
for the L.H. hitch tube.
8.
(Figure 6)
Fasten the hitch tubes together using two
5/16" x 2-1/2" hex bolts (A) and 5/16" nylock nuts (J).
Do not tighten yet.
6
5/16" x 2-1/2"
HEX BOLT (A)
5/16"
NYLOCK NUT (J)
ENGLISH
5
If your tractor hitch measures 10" to 13" above the
ground refer to figure 7. If your tractor hitch measures
8" to 10" above the ground refer to figure 8.
9.
(Figure 7 or 8)
Assemble the hitch brackets to the hitch
tubes using two 5/16" x 2" hex bolts (B) and 5/16" nylock
nuts (J). The bolts should straddle the front hitch tube
bolt.
Do not tighten yet.
10. At this time
tighten
the four bolts fastening the hitch
tubes to the sweeper housing. Next,
tighten
the two bolts
fastening the ends of the hitch tubes together. Finally,
tighten
the two bolts fastening the hitch brackets to the
hitch tubes.
11.
(Figure 7 or 8)
Assemble the hitch pin (Y), two 3/4" hitch
spacers (U) and the 1/8" hair cotter pin (M) to the hitch
brackets.
7
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH BRACKET
(BENT)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH PIN (Y)
8
5/16" x 2"
HEX BOLT (B)
5/16" NYLOCK
NUT (J)
3/4" SPACER (U)
HITCH PIN (Y)
HITCH BRACKET
(STRAIGHT)
1/8" HAIR
COTTER PIN (M)
HITCH BRACKET
(BENT)
