3
3. Turn the front angle assembly and bottom panel
upside down as shown in figure 3.
4. Lay each side angle on the bottom panel so that
the two holes (for the axle clamp) are closer to the
front angle assembly. See figure 3.
5. Secure both axle clamps to the side angles and
the bottom panel using four 1/4" x 1-1/4" screws,
lock washers and hex nuts.
Make only finger
tight
until the axle is assembled. See figure 3.
FIGURE 5
FIGURE 3
7. Stand the cart on end with the front angle assem-
bly down on the floor. Temporarily place the four
large 1-1/2" dia. flat washers (axle washers) on
the inside of front angle assembly. See figure 5.
These washers act as shims and are
just for assembly purposes. You will
remove them later to use on the axle.
NOTE
8. Lay the front panel down onto the front angle
assembly, on top of the four large 1-1/2" dia.
washers. See figure 6.
FIGURE 4
6. Assemble four 1/4" x 1" screws, flat washers and
hex nuts to the side angles and bottom panel
using the holes on each side of the axle clamps.
Tighten the four nuts.
See figure 4.
FIGURE 6
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
