4
FIGURE 8
FIGURE 7
9. Position a side panel against a side angle, resting
it down on top of the front panel. Place a support
strap on the outside of the side angle and start a
1/4" x 1" screw through the
second hole
in the
side panel, the side angle and the support strap.
Secure with a flat washer and hex nut.
Make only
finger tight at this time.
See figure 7.
10. Start a 1/4" x 1" screw through the top hole in the
side panel, the front angle assembly and the sup-
port strap. Secure with a flat washer and hex nut.
Make only finger tight at this time.
See figure 7.
11. Repeat steps 9 and 10 for the other side panel.
FIGURE 9
15. Lay the cart down on the floor so that the sides are
in the normal upright position. Remove the front
panel by sliding it up, then remove the four large
washers you used for shims. See figure 9.
12. Start one 1/4" x 1" screw through the bottom hole
in the side panel and the front angle assembly.
Start another 1/4" x 1" screw through the front hole
in the side panel and the side angle. Secure with
two flat washers and two hex nuts,
making only
finger tight at this time.
See figure 8.
13. Repeat step 12 for the other side panel.
14.
Tighten
all nuts and screws securely at this time,
except
for nuts and screws in axle clamps. See
figure 8.
For Agri Fab Discount Parts Call 606-678-9623 or 606-561-4983
www.mymowerparts.com
