13
discharging from the drain tube. Allow the
fluid to discharge until pure material is coming
out.
6.
Point the gun into the waste bucket, unlock
the trigger and hold the trigger open. Then
close the priming valve.
7.
Keep the trigger held open and allow the
pump to run and watch the fluid discharging
from the gun. Allow the fluid to discharge until
pure material is coming out. Turn the machine
off.
8.
To further bleed out any air, point the gun
into the material bucket or hopper and hold
the trigger open. Turn the machine on and
allow clean material to recirculate. Watch the
material to make sure there are no air bubbles.
9.
Now turn off the unit and lock the trigger
The drain tube may now be rejoined to the
suction tube in the material bucket.
( If you
are using a hopper, place the drain
tube in the hopper).
The unit is now primed and ready to install the tip
and tip guard.
SPRAY TIP ASSEMBLY (
reversible type tips)
WARNING: If the unit is pressurized, follow
the PRESSURE RELIEF PROCEDURE before
performing any adjustment with the tip.
Please see the section below
“Spray Tip Selection”
to choose the right tip for your application.
1.
Double check to be sure the gun safety latch is
locked before assembling tip and tip guard to
the gun.
2.
If it is not installed, ensure the seal is snapped
in place on the seat and insert the seat into
the tip guard. Make sure that it is aligned to
the circular opening in the tip guard.
3.
3. Thread the tip guard onto the gun finger
tight only.
4.
Insert the tip into the tip guard and ensure
that it is fully home. Rotate the tip all the way
to the forward position. (the arrow on the
tip handle will point forward). The tip can be
rotated 180 degrees for clearing clogs.
5.
Turn the tip guard assembly to the desired
orientation and tighten the lock nut firmly by
hand only.
WARNING: Never attempt to spray with the tip
in any position in-between either fully forward
or fully reversed. It could cause a high pressure
hazard.
You are now ready to spray.
PRESSURE RELIEF PROCEDURE.
Whenever you stop spraying, even for a short break,
follow the "Pressure Relief Procedure".
IMPORTANT! To avoid possible serious body
injury, always follow this procedure whenever
the sprayer is shut off, when checking it,
when installing, changing or cleaning tips,
when adding material and whenever you stop
spraying for any reason. Never leave the unit
unattended while in a pressurized condition.
1.
Engage the gun safety latch. (See page 11)
2.
Turn the unit off .(See page 3~5)
3.
Disengage the gun safety latch and trigger
the gun to relieve residual fluid pressure.
Hold metal part of the gun in contact with
a grounded metal bucket. Re-engage safety
latch.
Tip
Tip Guard
Seat
Seal
