13
Wolf-7 PRO
USER MANUAL
NOTE:
The sharpest image will only be visible when the objective lens and eyepiece lens are both
properly focused.
Bright Light Cutoff.
The device will automatically shut off after 70 (±30) seconds of operation in
daylight or bright room light. Individual bright lights (headlights, flashlights, or other concentrated
light sources) will not activate this function, unless the high light detector on the front of the device
is pointed directly at the light source. To turn the device back on in the event that this function is
triggered, flip the function switch to OFF position and then back to ON again.
2.3.2 IR ILLUMINATOR OPERATIONS
NOTE:
The built-in IR illuminator provides additional illumination (when needed) while viewing scenes or
targets from a short distance (up to 3 meters).
To turn built-in IR Illuminator on, pull the operation switch out and turn it from ON to the IR position.
LED indicator in field of view will appear and indicate the IR illuminator is operating.
Rotate the switch to ON position to deactivate the IR.
NOTE:
When you turn off the goggles, the IR illuminator will also turn off.
2.3.3 HEAD-MOUNTED OPERATION
Perform the following procedures for head-mounted operation.
1. Put the head mount on per the instructions in Paragraph 2.1.4.
NOTE:
Before attaching the goggles, loosen the eye relief locking knob and slide the head mount socket
all the way forward; this will make it easier to align the goggles, eyecups, and eyepiece lenses
with your eyes.
2. To set your eye relief, loosen the eye relief adjustment locking knob (Figure 2-6). Move the
goggles back towards your eyes until the eyecups are comfortably sealed around your eyes.
Tighten the locking knob.
HEAD MOUNT
SOCKET
RELEASE LEVER
EYE RELIEF ADJUSTMENT
LOCKING KNOB
TILT ADJUSTMENT KNOB
VERTICAL ADJUSTMENT
LOCKING KNOB
FIGURE 2-6. HEAD/HELMET MOUNT ADAPTER OPERATION
