AGM PA-15, Instruction Manual, Page: 35 / 42

35
SET-UP FOR WELDING POWERBASE PINS AND DOUBLE POINTED PINS
Steel/ Stainless
Powerbase Pin
Collet
Protector
Polarity Voltage
12 Gauge (2.69mm)
437-106
437-P-106
Standard 150
10 Gauge( 3.42mm)
437-135
437-P-135
Standard 200
CAUTION: DO NOT USE POWERBASE PINS ON METAL LESS THAN 1/16” THICK.
WELDING PROCEDURE
Insert the weld pin and place it against the welding surface. Push the gun down until the
shaft is fully depressed. Then, while holding the gun firmly and perpendicular to the weld
surface, actuate the weld cycle. If the cycle does not initiate the gun should be rotated
around the weld point in order to penetrate surface scale, paint etc. Then actuate the weld
cycle again.
Note: The 2318-M adjustable foot piece is not required when welding Powerbase and
double pointed pins shorter than 2-1/2”. For these pins use proper collet, protector and
stop. For 2” pins use 437-G-1250 stop and 1” pin use 437-G-0750 stop.