27
SET-UP FOR WELDING 5/16-18, 5/16 SHOULDER & 3/8-16 STUDS
GUN SET-UP WITH HEAVY 3” SPRING AND 2318-M FOOT PIECE
ASSEMBLY
A.
Install proper stop (1) and collet (2). Be sure the collet holding set screws
are tightened securely.
B.
If previously installed, remove 1151-M legs from the face plate.
C.
Insert adjustable legs of foot piece into the holes in the face plate.
D.
Insert proper spark shield into the foot piece and tighten set screws.
E.
Insert stud through spark shield and into the collet until it rests against the
stop.
F.
Check for freedom of movement between the spark shield and the stud. If
they bind, loosen the two cap screws and move the foot piece until the
stud is centered in the spark shield. Tighten the cap screws.
G.
Adjust the foot piece by loosening the two set screws and sliding the
assembly as required. The stud should extend beyond the spark shield
approximately 1/4” as shown. Tighten the set screws.
The gun is now ready for welding.
Summary of Contents for PA-15
