AGM PA-15, Instruction Manual, Page: 18 / 42

18
OPERATING SUGGESTIONS
Re-check application sheet
Do Keep collet adapter assembly in good condition.
Make sure correct collet is in place and that the set screws are tightened
securely.
Make sure correct protector or stop is in place.
Make sure the gun shaft has smooth motion.
Make sure legs are used when required and are tightened securely.
Insert pin or stud into collet until it makes firm contact with the protector
or stop.
Hold gun perpendicular to the welding surface.
Hold gun steady when welding.
Remove gun in straight-line motion from welded pin or stud.
Make sure all control and weld cable connections are kept tight and clean.
Make sure voltage setting and ground polarity is correct for the
application.
When used, keep spark shield as clean as possible.
Do Not Use worn or wrong size collet.
Use worn, broken, or wrong size protector.
Use wrenches or pliers on the gun shaft.
Use Center Punch to locate pin or stud.
Pull welder by cables.
Leave weld cables coiled up while welding.
Use wrong ground polarity for the application.
Use pins or studs not designed for use with the AGM PA-15 Welding
System.
Care must be taken to operate this welder on the rated
AC line voltage range (95-130 VACS) only .
Failure to do so will damage the welder.