7
Anaconda-Micro
USER MANUAL
2 OPERATING INSTRUCTIONS
2.1 INSTALLATION AND MOUNTING
2.1.1 UNPACKING
The following steps must be completed prior to each mission.
1. Open the carrying bag, remove the device, and verify that all components are ac-
counted for.
2. Inspect the device for any obvious evidence of damage to the optical surfaces, body,
operation joystick, etc. Ensure that all optical surfaces are clean and ready for use.
Clean all optical surfaces with a lens tissue.
2.1.2 BATTERIES INSTALLATION
Turn the battery cover knob clockwise until stop and remove the cover from battery
compartment (see the Figure 2-1, OPEN position). Install two CR123A batteries in
opposite polarity direction (Figure 2-2).
Turn the battery cover knob counterclockwise until stop. The latches from both sides of
the cover will pull out. Replace the battery cover and press it until its clicking position.
(see the Figure 2-1, CLOSE position). Make sure the cover is closed on both sides.
OPEN
Pull
CLOSE
Press
FIGURE 2-1. BATTERY COMPARTMENT
FIGURE 2-2. BATTERY POLARITY
