Agilent Technologies TS-5410, Site Preparation And Installation Manual

Page: 3 / 30

Safety and Support Information 3
Safety Summary
The following general safety
precautions must be observed
during all phases of operation of
this system. Failure to comply
with these precautions or with
specific warnings elsewhere in
this manual violates safety
standards of design,
manufacture, and intended use
of the system. Agilent
Technologies, Inc. assumes no
liability for the customer's
failure to comply with these
requirements.
General
This product is provided with a
protective earth terminal. The
protective features of this
product may be impaired if it is
used in a manner not specified
in the operation instructions.
WARNING:
DO NOT OPERATE
IN AN EXPLOSIVE ATMOSPHERE
Do not operate the system in the
presence of flammable gases or
flames.
If the equipment in this system
is used in a manner not
specified by Agilent
Technologies, the protection
provided by the equipment may
be impaired.
Cleaning Instructions
Clean the system cabinet using a
soft cloth dampened in water.
WARNING:
DO NOT REMOVE
ANY SYSTEM COVER
Operating personnel must not
remove system covers. Component
replacement and internal
adjustments must be made only by
qualified service personnel.
Equipment that appears damaged or
defective should be made
inoperative and secured against
unintended operation until they can
be repaired by qualified service
personnel.
Environmental Conditions
Unless otherwise noted in the
specifications, this system is
intended for indoor use in an
installation category II,
pollution degree 2 environment.
It is designed to operate at a
maximum relative humidity of
80% and at altitudes of up to
2000 meters. Refer to the
specifications tables for the ac
mains voltage requirements and
ambient operating temperature
range.
Before applying power
Verify that all safety precautions
are taken. Note the external
markings described in
“Safety
Symbols and Regulatory
Markings”
on page 4.