Agilent Technologies E2969A, User Manual

Page: 37 / 52

Troubleshooting
E2969-91020 4-5
If the output shows
SMP
, the multi-processor kernel has been started.
Reboot the target platform and make sure to select the uni-processor
kernel when queried in the booting process.
•
Make sure that the Linux driver for the PTC is installed.
Start a Test and without closing the software, open a console window
and type
lsmod
.
The output should contain the following drivers:
•
splus
•
ttpi_splus_kernel_lib
•
pcie_user_config_driver
•
pcie_config_lib
•
DevMgmtLib
•
complib
If the output shows the above drivers, all drivers got installed
correctly. Otherwise you can load the driver subsequentially:
Open a console window and enter the following commands
–
insmod /lib/modules/2.4.20-8/misc/complib.o
–
insmod /lib/modules/2.4.20-8/misc/DevMgmtLib.o
–
insmod /lib/modules/2.4.20-8/misc/pcie_config.o
–
insmod /lib/modules/2.4.20-8/misc/pcie_user_config_driver.o
–
insmod /lib/modules/2.4.20-8/misc/ttpi_splus_kernel_lib.o
–
insmod /lib/modules/2.4.20-8/misc/splus.o
The Linux driver is now installed.
Windows
•
Go for sure, that you have the right Bus/Device/Function number for
the DUT
•
Check the installation of the AIC drivers as it is shown in the
Installation chapter.