Agilent Technologies Agilent 35900E, User Manual

Page: 44 / 60

44 User Manual
6
Parts Replacement
3
Remove the four screws holding the front panel to the unit.
4 Gently pull the front panel forward until it detaches from the frame.
5
Remove the ground wire connection (green wire) from the ground clip by
pulling it firmly.
6 When you are ready to replace the front panel, reattach the green ground
wire to the ground clip on the chassis.
7 Fit the bottom lip of the front panel under the lip of the frame and push it
against the frame, fitting the power switch into the hole.
8 Connect the front panel cable to the connector, pressing firmly until the
ears of the connector lock over the ends of the black connector.
9
Replace the four screws, two on each side.
Remove the MIO Bracket
1
Remove the top cover. (See “Remove/Replace the Top Cover” on page 42.)
2 Remove the MIO card. (See “Connecting to a TCP/IP Network” on page 20.)
3
Remove the three screws attaching the MIO bracket to the frame. (See
Figure 15 on page 51.)
4 Firmly pull up on both the plate and the connector board, holding them
together at a right angle.
Remove the Connector Board
1 Remove the top cover. (See “Remove/Replace the Top Cover” on page 42.)
2 Remove the MIO bracket. (See “Remove the MIO Bracket” on page 44.)
3
Remove the two screws attaching the connector board to the plate. The
board will separate from the plate. (Figure 15 on page 51.)
WA RN I N G
This procedure is intended for use by Agilent-trained service personnel only. There
are no user-serviceable parts inside the 35900.
WA RN I N G
This procedure is intended for use by Agilent-trained service personnel only. There
are no user-serviceable parts inside the 35900.