31025 R0
39
7
7.. T
Trro
ou
ub
blle
es
sh
ho
oo
ottiin
ng
g
Before continuing, ensure you have completely read and understood this manual’s
Safety section, in addition to the safety information in the section(s) below.
This manual is a supplement to the X130 Series Operator Manual. Please ensure that
you have read and understood that manual.
Shut down and lock out all power sources before diagnosing any of the causes or
attempting any of the solutions below.
In the following section, we have listed some causes and solutions to some of the problems you may
encounter.
If you encounter a problem that is difficult to solve, even after having read through this section, please
contact your local dealer or distributor. Before you contact them, please have this operation manual
and the serial number from your machine ready.
Problem
Cause
Solution
Low capacity
Tractor PTO rpm is set too
slow
Adjust the tractor to 1000rpm if using a
reducer gearbox and 540rpm if not using a
reducer.
Sprocket that moves
the retractor tube in
and out is slipping on
chain.
The retractor tube chain is not
close enough to the sprocket.
Loosen the bolt that attaches the guide
bearing. Adjust the tensioner bolt to push
the guide bearing against the track to
move the chain closer to the sprocket. Re-
tighten the guide bearing bolt.
Hydraulic functions
are too fast.
Hydraulic flow is set too high
on tractor.
Lower the hydraulic flow on the tractor.
Should be approximately 8 GPM.
X-TEND HOPPER – X130
