8210-00001 R0
25
Figure 4.
Typical Grain Conveyor Placement for Filling Bins
KEEP AWAY!
OVERHEAD WIRES
wheel chocks
Under Hopper Bottom Bins
1. Center the conveyor between the hopper bin’s vertical legs.
2. Collapse the cloth hopper until the conveyor is fully positioned under the bin.
3. Move the conveyor into place. Do not allow the conveyor tube or components to contact the bin.
4. Raise the conveyor to the desired height.
5. Make sure that gravel is not jammed against the belt under the hopper.
6. Place chocks in the front and back of each wheel and anchor the intake end.
5.3. Hand Winch Operation
Æ
When equipped with a Hand Winch:
Before using the hand winch, ensure that:
• the cable anchor on the winch drum is tight.
• all cable clamps are secure.
• the lift cable is seated in cable pulley.
• the cable is in good condition, if damaged, replace it immediately.
• there is a minimum of 3 cable wraps on the winch drum when the conveyor fully lowered.
To operate:
1. Turn the winch handle to raise and lower the conveyor. The winch must make a clicking sound when raising
the conveyor. If clicking sound stops, retain grip on handle, lower the conveyor fully and repair winch.
2. When lowering, if the cable becomes slack before conveyor is in full down position, this indicates that the
track shoe is stuck. To correct the problem, reverse the winch and raise the conveyor until the cable is taut
and the track slides normally. Do not lubricate the winch brake discs.
PTO TOP-DRIVE FIELD LOADER – PORTABLE GRAIN BELT CONVEYOR
