8210–00011 R1
67
Problem
Cause
Solution
Flashing installed incorrectly
or worn.
Inspect flashing for wear and replace if
required.
Hopper cloth worn or
damaged.
Replace damaged hopper cloth.
When equipped:
Transition
filler rings are worn.
Replace transition filler rings.
Hopper cloth
collapsing under grain.
Misaligned or broken spring
(s).
Check spring installation and repair as
required.
Pivot shafts improperly
installed.
On some machines, switching pivot shafts
left to right will increase hopper tension.
Grain leaking from
conveyor discharge
between belt and
tube.
Belt not aligned (centered).
Align belt, see Belt Alignment in
Maintenance.
Grain leaking from
conveyor discharge
between hood and
belt.
Belt speed is too fast, hood
plugging.
Decrease belt speed, see Belt Speed in
Operation.
U-clamps or brackets
sliding on tube.
U-clamps or brackets not
properly crimped to tube.
Contact dealer or AGI to correct
positioning.
Drive
Problem
Cause
Solution
Drive making noise.
Hot shaft, pulley or bearing.
Overheated components indicate a failed
bearing that must be repaired.
Broken drive roller.
Replace damaged component.
SWING-AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
