56
8210–00011 R1
7.8. Inspect Hydraulic Hoses and Fittings
Æ
When equipped:
1. Pressurize the system.
2. Using a piece of cardboard or wood, run it along the length of the hose and around all fittings.
Escaping hydraulic fluid under pressure will cause serious injury if it penetrates the skin
surface.
3. Replace the hose or tighten/replace the fitting if a leak is found. For replacement hoses, refer to
.
4. Replace any hose that is badly cut, nicked, abraded, or is separating from the crimped end of the fitting.
5. Secure hoses to the machine.
7.9. Inspect the Hopper Flashing
Check hopper flashing for wear and replace any that are worn. Worn flashing will cause hopper leakage.
7.10. Check the Roller Bearings
Check the roller bearings for wear. Any rollers making noise, getting hot while running, or that give should be
replaced.
7.11. Check the Rollers
Inspect the roller to see if it is showing signs of wear. Replace rollers that are worn.
Operating the conveyor with a damaged roller will result in a damaged conveyor belt.
7.12. Tension the Conveyor Belt
Adjusting your conveyor belt for proper tension helps to ensure trouble-free operation and long belt life.
The conveyor belt only needs to be tight enough to not slip on the drive roller. If the belt is too loose, it will slip
on the drive roller making a noticeable sound, slowing the belt down.
The conveyor belt should not be easy to pull from the hopper transition sides, otherwise the belt will require
tensioning.
Failure to stop using the conveyor with a slipping belt will damage it and/or the drive roller. In
extreme cases, sections of burnt belt will have to be replaced. This type of damage is not
covered by warranty.
To set correct conveyor belt tension:
1. While the conveyor is running empty, fully tighten the nut against the pretensioner (take-up pipe) so that
the edge of the indicator pipe is within the green area, see
SWING-AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
