54
8210–00011 R1
Æ
10.
PTO Models:
Check the PTO shield & replace if damaged.
Æ
11.
If equipped with truss cables:
Inspect the truss cables for proper tension and possible damage such as
fraying, kinking, or unwinding.
Æ
12.
If equipped with a hand or hydraulic winch:
Inspect winch cable for fraying, kinking, unwinding, or other
possible damage.
7.4. Lubricate the Equipment
Your equipment can operate at top efficiency only if clean fluids and lubricants are used. Use clean containers
to handle all fluids and lubricants. Store them in an area protected from dust, moisture, and other
contaminants.
1. Wipe the grease fittings with a clean cloth before greasing to avoid injecting dirt and grit.
2. Use a hand-held grease gun for all greasing.
3. If fittings will not take grease, remove and clean thoroughly.
4. Replace fittings if they are broken or will not accept grease.
5. If Intake Bushing is present in your auger, lubricate it.
Use SAE multi-purpose high-temperature grease with extreme pressure (EP) performance. SAE multi-purpose
lithium-based grease is also acceptable.
7.4.1 PTO Driveline
Figure 22.
Typical PTO Driveline Grease Points
Figure 23.
Typical PTO Driveline Grease Points
7.5. Oil the Chain Coupler
The chain coupler is located between the hydraulic motor and the conveyor’s drive roller.
SWING-AWAY CONVEYOR – PORTABLE GRAIN BELT CONVEYOR
