AGFA Jeti Tauro H3300LED Series, Operator'S Manual

Page: 71 / 113

Jeti Tauro H3300LED Operator Manual
63
Agfa Graphics
Chapter 5
Recovering from an Interlock Error
Table: describes causes and solutions for interlock trip errors.
Error Message Corrective action
One of the operator doors is not properly
closed. • Close both operator doors.
The drip tray is not home. • Lock the drip tray in home position.
The shuttle has reached one of its ends of
travel sensors. • Move the shuttle by hand toward the middle
of the Jeti Tauro H3300LED beam.
• Initialize the printer using the Re-init com-
mand. This will take a few seconds if the inter-
lock tripped while the system was idle and a
few minutes if it was in operation.
Recovering from a Collision Error
Perform the following procedure to recover from a collision error.
Procedure 5-8: How to Recover from a Collision Error
- Step 1: When one collision sensor encounters the media, the shuttle stops immediately and the
Crash Recovery Wizard window automatically pops up.
- Step 2 Click on the Release Media button
(outlined in red in Fig.5-44)
. This moves the
carriage up, away
from the media. When this command is successful, the Finish button becomes active.
Fig.5-44: Crash Recovery Wizard Pop Up Window
Note : The Roll bar and vacuum commands are available if needed.
- Step 3: Open the operator door and manually remove the media.
Important: In this situation, although the operator door is open, the printer software
allows the
vertical movement of the carriage.
Revision 1.0