AGFA Jeti Tauro H3300LED Series, Operator'S Manual

Page: 15 / 113

Jeti Tauro H3300LED Operator Manual
07
Agfa Graphics
Chapter 1
Emergency Stop Button Operation
Emergency stop button activation immediately triggers the following actions:
• All shuttle and media transport belt movements are stopped
• The media transport belt vacuum, the vacuum air system and the UV lights shut down
• Communication to the electronic boards is interrupted
After an emergency stop, the user needs to perform the following actions in order to put the Jeti
Tauro H3300LED back into production:
• Prior to re-initializing the system, the operator should resolve the issue that warranted the manual
or caused the automatic emergency stop. Make sure that system and operator safety precautions are
taken prior to re-activation.
• When the operator cannot achieve safe operating conditions or system re-activation in a short peri-
od of time (minutes), he should move the shuttle to home position by hand, because ink could start
dripping from the heads. Contact your service organization or seek advice within reasonable time (15
minutes).
• If by any reason, physically or safety wise, the operator cannot move the shuttle to home position,
place a sheet of impermeable or absorbing material under the shuttle to collect and absorb possible
ink leakage and contact your service organization as soon as possible.
• When the system and the operator are safe, rotate the emergency stop button to reset it.
•
On the printer console GUI, press the “Re-init” button in the alarm window
• The system should recover after a few minutes.
Revision 1.0