AGCO ROGATOR 418, Operator'S Manual

Page: 66 / 86

MAINTENANCE
06.11
Maintenance
11-04
RoGator 418
Tyre Pressure Chart
Kleber Super 3 300/95 R46 TL 147A8 Speed = 100%
Width Diameter
1.8 2.2 2.6 2.8 3.0 3.2 3.6 Km/h
2030 2260 2500 2610 2730 2840 3080 40
2160 2420 2670 2780 2920 3030 3280 30
2360 2630 2900 3040 3180 3320 3590 15
309 mm 1724 mm
2420 2700 2980 3120 3260 3410 3690 10
Kleber Traker 420/85 R38 TL 144 A8
Speed = 96%
Width Diameter
1.0 1.2 1.3 1.4 1.6 2.1 Km/h
1980 2180 2280 2380 2575 50
2160 2370 2480 2590 2800 40
2310 2540 2650 2770 3000 30
445 mm 1665 mm
2790 3050 3180 3300 3560 4200 10
Michelin XM 108 540/65 R38TL 147A8
Speed = 98%
Width Diameter
0.6 0.8 1 1.1 1.2 1.4 1.5 Km/h
1880 2080 2280 2310 2480 2680 50
1880 2180 2480 2510 2780 3080 40
2010 2330 2650 2690 2970 3290 30
520 mm 1683 mm
2440 2840 3230 3270 3630 4020 3980 10
Wheel Maintenance
IMPORTANT: DURING BREAK-IN Period.
Loosen each wheel during the first 50 hours of
operation according following procedure:
1. 1/4 turn,
2. Tighten to a torque of 250 Nm,
3. Tighten each wheel mounting bolt accord-
ing to wheel bolt tightening sequence pic-
ture,
4. Tighten to a torque of500 Nm,
5. Retighten every 500 hours of operation.
Removing the Wheels
1. Put the vehicle on a hard, level surface. Place
blocks behind the wheels that are not being
removed.
2. Lift the vehicle and support it with safety
stands. Use safety stands that will support the
weight of the vehicle.
WARNING
!
Never support the vehicle only
with a jack or supports that
can crumble. Injury or death
can result.
3. Remove the wheel nut and the lock washer,
using metric tools.
4. Remove the wheel from the axle with a second
person.
CAUTION
!
Use the proper equipment when
removing the wheel from the axle.
Injury or death can result.
Installing the Wheels
1. The wheel mounting surfaces of the wheel
motor, the wheel disc and the back of the
wheel nut must be true and clean.
2. Position the wheel over the wheel motor, tak-
ing the position of the wheel nut into consid-
eration.
3. Tighten the wheel nut by hand. First tighten
opposite wheel nuts to 250 Nm and then to
500 Nm.
Wheel Bolt Tightening Sequence