AGCO MF 9205, Workshop Manual

Page: 40 / 41

MF9205 10-100-2 1857 768 M1
Workshop Manual
HYDRAULIC/HYDROSTATIC SYSTEM (CONT’D)
Replacing Hydraulic Fluid
Use only recommended fluid in the hydraulic system. (See
HYDRAULIC/HYDROSTATIC FLUID SPECIFICATIONS
on Page SPEC-50-1.)
Stop the machine on a level surface. Lower the boom all
the way and tilt the Bob-Tach fully back.
Stop the engine.
Figure 10-100-4
Remove the fill cap (Item 1) [Figure 10-100-4] at the front
left side of the Telescopic Handler.
WARNING
AVOID INJURY OR DEATH
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks. Do
not use your bare hand. Wear safety goggles. If fluid
enters skin or eyes, get immediate medical attention
from a physician familiar with this injury.
W-2072-0807
WARNING
AVOID INJURY OR DEATH
Always clean up spilled fuel or oil. Keep heat, flames,
sparks or lighted tobacco away from fuel and oil.
Failure to use care around combustibles can cause
explosion or fire.
W-2103-0508
Figure 10-100-5
Remove the reservoir drain plug (Item 1) [Figure 10-100-
5] behind the right front tire and drain the fluid into a
container. Recycle or dispose of the fluid in an
environmentally safe manner. Reinstall the drain plug and
tighten.
Figure 10-100-6
Add fluid until visible in the sight gauge (Item 1) [Figure
10-100-6] behind the front left tire.
Install the fill cap (Item 1) [Figure 10-100-4].
S6545
1
S2373
1
S3322
1