AGCO MF 9205, Workshop Manual

Page: 26 / 41

MF9205 10-40-2 1857 768 M1
Workshop Manual
TOWING THE TELESCOPIC HANDLER (CONT’D)
Towing
Figure 10-40-3
Raise the engine cover.
Turn the tow valve (Item 1) [Figure 10-40-3]
counterclockwise 90 degrees to TOWING POSITION.
Tow the Telescopic Handler at a slow speed.
NOTE: The vehicle will not be able to brake until the
four bolts (Item 1) [Figure 10-40-3] & [Figure
10-40-3] are returned to their original position.
Block the wheels to prevent the machine from rolling.
After towing is completed, turn the tow valve (Item 1)
[Figure 10-40-3] clockwise 90 degrees to the
OPERATING POSITION.
NOTE:If the tow valve is not returned to the operating
position, the machine will not be able to be driven forward
or backward.
Engaging The Brake Discs
Figure 10-40-4
Loosen the four bolts (Item 1) until the spacers (Item 2)
[Figure 10-40-4] can be installed under the bolt heads
(the bolts and washers are located on both the front and
rear side of front axle).
Figure 10-40-5
Evenly tighten the front and rear bolts (Item 1) to hold the
spacers (Item 2) [Figure 10-40-4] & [Figure 10-40-5].
Tighten the bolts to 95-115 N•m (70-85 ft-lb) torque.
This will allow the parking brake piston (Item 3) [Figure
10-40-5] to be active again.
S2696
1
Operating
position
Towing
position
S2711
1
2
1
2
P-68946
1
3
RELEASED POSITION
ACTIVE POSITION
2