AGCO MF 9205, Workshop Manual

Page: 39 / 41

1857 768 M1 10-100-1 MF9205
Workshop Manual
HYDRAULIC / HYDROSTATIC SYSTEM
Checking And Adding Fluid
Use only recommended fluid in the hydraulic system. (See
HYDRAULIC/HYDROSTATIC FLUID SPECIFICATIONS
on Page SPEC-50-1.)
Stop the machine on a level surface. Lower the boom all
the way and tilt the Bob-Tach fully back.
Stop the engine.
Figure 10-100-1
Check the fluid level at the sight gauge (Item 1) [Figure
10-100-1] behind the front left wheel.
Figure 10-100-2
Clean the area around the hydraulic fill cap.
Remove the fill cap (Item 1) [Figure 10-100-2] at the front
left side of the Telescopic Handler and add hydraulic fluid
until visible in the sight gauge.
Install the fill cap.
Replacing The Hydraulic / Hydrostatic Filters
For the correct service interval for replacing the hydraulic /
hydrostatic filters. (See SERVICE SCHEDULE on Page
10-50-1.)
Figure 10-100-3
Stop the engine and open the engine cover.
Remove the two filter elements (Items 1 & 2) [Figure 10-
100-3].
Clean the surface of the filter housings where the filter
seals contacts the housings.
Put clean oil on the seals of the new filters. Install and
hand tighten the two new filter elements.
WARNING
AVOID INJURY OR DEATH
Diesel fuel or hydraulic fluid under pressure can
penetrate skin or eyes, causing serious injury or
death. Fluid leaks under pressure may not be visible.
Use a piece of cardboard or wood to find leaks. Do
not use your bare hand. Wear safety goggles. If fluid
enters skin or eyes, get immediate medical attention
from a physician familiar with this injury.
W-2072-0807
S3322
1
S7162
1
S2695
1
2