AGCO 4 - 4
MF 2600 H Series Workshop Service Manual
Splitting the tractor
11.
Support the front axle assembly using crane and
chains.
12.
Support the tractor under the engine sump using
suitable stand.
13.
Remove front support casting securing bolts and
nuts.
14.
Carefully roll the two front wheels, front axle and
crane forwards away from the engine.
Splitting the tractor between the engine and transmission
4A.3SPLITTING THE TRACTOR
BETWEEN THE ENGINE AND
TRANSMISSION
Splitting Procedure
Special Tool
SER / 054 - Tractor spliting stand
Removal
1.
If the tractor is four-wheel drive, first disconnect the
drive shaft at the front axle end. To turn the drive
shaft to gain access to the coupling split pin it may
be necessary to move the tractor under power. The
shaft cannot be turned without the engine running.
Remove the drive shaft assembly
.
2.
Apply the tractor parking brake and fit wheel chocks
to hold the rear wheels.
3.
Disconnect the battery terminals and remove the
battery earth cable and battery.
4.
Disconnect the head light wiring connections and
disconnect the alternator,starter motor , electrical
plugs of harness (4)
t
hat joins the front and rear
parts of the tractor
remove the bonnet / hood from
the tractor.
5.
Disconnect the air cleaner hose.and the inlet
manifold.
Refitment
For reassembling, follow the reverse procedure
above,
1.
Reconnect the hydrostatic steering cylinder
hoses to the steering cylinder and bleed air from
the system.
2.
Tighten all bolts and nuts as per the torque value.
6.
Drain the transmission oil and disconnect the
hydrostatic steering hoses and pipe joints from
the tractor rear end to the front end.
7. Remove the heat and dust deflectors the cover
and steps from both side of the tractor
8.
Disconnect the hoses from the fuel system and
remove the fuel sender unit connections.
9.
Remove the two bolts securing the battery
platform to the rear of the Engine.
10.
Disconnect the front wiring harness.
11.
Disconnect tractormeter drive cable from the rear
of the engine.
12.
Release the clutch mechanism, through the pin
disconnect the foot throttle control rod the throttle
control linkages from the injection pump,
Remove the supports which fits the instrument
panel assy to the gear box housing.
13.
Loosen the Starter motor bolts and remove the
starter motor with gasket.
14.
Release the actuating brake and clutch rods
through pins. casting and centre beam to avoid
pivoting.
Splitting the tractor in between the engine and transmission
