AGCO HayBoss G2 596, Operation Manual

Page: 30 / 64

For AGCO part cross-reference visit: www.harvesttec.com/system.html
30
Harvest Tec outputs.
System leaks product out of tips after
shut down. 1. Dirty or defective check valves. 1. Clean or Replace.
Terminal reads under or over power. 1. Verify with mult-meter actual
voltage. Voltage range should be
between 12-14 volts. 1. Clean connections and make sure
applicator is hooked to battery. See
Diagnostics section of manual.
System does not pause at the end of a
row. 1. Short in cable.
2. Damaged sensor.
3. Bad alignment of sensors 1. Replace cable.
2. Replace sensor
3. Check 474 manual for alignment
instructions
Bale rate displays zero. 1. Bale rate sensors are reversed.
2. Short in cable.
3. Damaged sensor. 1. Switch the sensors next to the star
wheel.
2. Replace cable.
3. Replace sensor.
Display will not power up. 1. Connection broke between the
display and the PIP.
2. Short in display cable. 1. Check, clean, and tighten
connections.
2. Replace cable.
Display is too dark or light 1. Change in temperature or light
conditions. 1. Use the monitors contrast control.
Display is locked up/froze.
1. CAN communication not
responding.
2. Broke connection between the
display and PIP or Pump control
and PIP. 1. Check connections at PIP and Pump
controller including the terminating
resistors.
2. Check, clean, and tighten
connections.
3. Power unit down and restart after
steps 1 & 2 are complete.
Display powers up when key is turned
and will not go to the Main Menu screen. 1. CAN communication not
responding.
2. Broke connection between the
display and PIP or Pump control
and PIP. 1. Check connections at PIP and Pump
controller including the terminating
resistors.
2. Check, clean, and tighten
connections.
3. Power unit down and restart after
steps 1 & 2 are complete.
Display is locked up/froze and pumps
continue to run. 1. CAN communication not
responding.
2. Broke connection between the
display and PIP or Pump control
and PIP. 1. Check connections at PIP and Pump
controller including the terminating
resistors.
2. Check, clean, and tighten
connections.
3. Power unit down and restart after
steps 1 & 2 are complete.
Display says PAC error 1. The PIP and Pump controller
are not communicating.
2. Broke connection between the
display and PIP or Pump control
and PIP. 1. Check all connections at PIP and
Pump controller including terminating
resistors.
2. Check, clean, and tighten
connections.