6
Ludlow Standard Model ECG
– Natural Gas
2. User Instructions
– Important Please Read
2.1 Emergency Gas Isolation -
Installation of the Gas Isolation Tap with Pressure Test Point
This stove must be fitted with a
Gas Isolation Valve to the side or the rear of the stove which can
be easily accessed by the user
MANDATORY REQUIREMENT
- When installing this stove the Gas Safe Installer must fit
a gas isolation valve at the rear or side of the stove with a pressure test point incorporated into
the ON / OFF Tap
– this will used to test the gas Inlet/Standing Pressure - Please make the
customer aware of where this valve is fitted and that they can access it easily
Gas Isolation Valve
–
We recommend you turn the gas supply OFF to the stove if you are not using it
for a long period of time, please use the gas isolating ON/OFF valve that your fitter would have installed
when the stove was fitted.
This
Gas Isolation Valve
is not part of the components AGA supply with the stove, your installer will
supply this. Please note it must have a gas pressure test point built into the valve
In the event of a gas leak or if gas is smelt, the appliance must be isolated. This is done by turning OFF
the gas at the
ON / OFF
Isolation Tap. This Isolation Tap should be fitted to the rear or side of the
appliance, with easily access to operate.
Also turn off the Gas Control Valve via the ON/OFF slider switch which is mounted at the front of the
stove at the bottom
This stove is fitted with an 8mm diameter compression fitting on the
end of the flexible gas inlet pipe.
From this flexible inlet pipe - the gas isolation tap must be fitted. This
must be fitted so the customer is able to easily access and isolate the
gas supply to the stove if required
If any foreign objects are found in the Gas Control Valve such as
brick dust, this is not covered by the AGA Warranty
2.2 First Time of Operation
Before igniting the appliance, ensure that all packaging, safety stickers and any protective wrapping
have been removed, and that the glass has been cleaned, including all fingerprints from the glass.
Ensure that the room is adequately ventilated the first time that the appliance is ignited; we would
recommend opening windows if possible.
Curing the Paint
– First Time Usage
Run the appliance at a 25% setting for a 1 hour
Then at a 50% Setting for 1 hour
Then Finally on Full Power 100% for 1 hour
This will then allow the paint the opportunity to fully cure. During this period it is possible
for some fumes and vapours to be given off.
We would recommend keeping children and pets out of the area at this time.
Please Note:
When using this stove with the manual controller, the manual controller is located at the front of
the stove at the bottom in the middle. When the stove has been running/burning for a short
period of time the stove will become HOT - please be careful if using the manual Controller when
the stove is hot, we recommend you use the Remote Handset to operate this stove
In the Hot zone at the front of the stove, do not place to dry laundry as if could cause a FIRE, if
children, the elderly or persons with limited mobility
are in the room unoccupied a Fire Guard
must be installed
